poolplayer2093 Status: OfflineAzB Silver Member |
Last Activity: 10-16-2014 12:41 AM
About Me
- About poolplayer2093
- Biography
- playing cue queperfect
- Location
- Stockton CA
- Interests
- Pool,casino,working out
- Occupation
- Job??
Blog
View poolplayer2093's BlogRecent Entries
Latest Blog Entry
Posted 06-11-2014 at 07:11 PM by poolplayer2093
Comments 0
Posted in Uncategorized
Quote:
Got a nice Exceed cue with 4 shafts,
4 shafts (all Mezz shafts) all comes with Kamui Original M tip 1. hybrid pro 2, used, heavy bluing 2. wx700, some bluing 3. hybrid alpha, this hit a few racks at best, very minimal use, no bluing on shaft, some minor bluing on ferrule, probably got it from the case, very new 4. mezz hard maple shaft, same condition as (3), very new all shafts are still more than 13mm. wavy joint |
Posted 04-26-2014 at 04:27 AM by poolplayer2093
Comments 0
Posted in Uncategorized
What's the point of that at all. This whole "constitution free zone" bs is all the power they need. This document hat makes us free and defines what we should constantly strive to be as a nation applies to every American in America........that is until the gov decides some group is causing too big a commotion. Then it just gets ignored in the area that those particular Americans are in....
Posted 01-31-2014 at 11:22 AM by poolplayer2093
Comments 0
Posted in Uncategorized
Quote:
Eventually ill get a lathe, but until then I need a way to really burnish the sides of my tip so that it's really shiny. I really like how a tip plays when it's burnished good and the sides are hard and shiny.
I have a joe proper plastic burnisher but it seems too tricky since you can't see what it's doing until you pull it off. Sometimes depending on the shaft it'll make the overly conical. Any advice? Anyone use the tip burnishing liquid from tiger? Thanks, |