...

‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎ ‎‎‎‎‎‎‎‎‎

http://emptycharacter.com/

...

..............

......................

QUOTE=fishermanOICUR1;6578641]I sell the blank tubes from China for $75, paypal F&F, I pay shipping CONUS. They are 12.75 at tip, .848 at joint, 30" long. You can have your cuemaker/repairman finish them out to your specs. Terry Aeschliman Galveston Indiana[/QUOTE]

[QUOTE=Pete Tonkin;6570043]Yes the front is tapered before I cut point slots
I use the dia at the forearm base as a reference.

1.150 cut point slots
1.125 A joint ring and bridge work if needed
1.100 install handle
1.082 inlay work
1.072 second round of inlay work if needed
1.062 finish size[/QUOTE

QUOTE=cwong79;6567513]It’s an oversized blank by Rounceville.

I would like a single card suits within every point. Diamond, spade, heart, etc. With this type of paua inlay ~

https://luthiersupply.com/121/292/pr...nlay-0180.html

Joint and buttcap from buffalo horn with paua inlay. Kinda like what Ed Prewitt does.

Here is the joint type,

http://mezzcue.com/en/technology_poo...t/united_joint[/QUOTE]

=jrctherake;6564721]I was curious so, I had my cue guy put a ferrule on my revo long before most other cf shafts with ferrules came out.

I had my cue guy glue a very, very thin fiber pad directly to the red pad.

Then I had him glue a piece of tomahawk to the fiber pad...

Then my tip..

I started out with a full .5" ferrule. It was to much and totally changed the deflection properties of the revo.

So, I then had him tip...