Phenolic inserts for shaft
Posted 04-06-2020 at 01:39 PM by Snooker Theory
Quote:
Originally Posted by Ssonerai
Hmmm.... will have to dig deeper. Initial searches just showed rod from flat lam material, which was the reason i "rolled" my own, so to speak - ripped some sheet and turned short sections of rod on the lathe.
This is close to what i need for furniture project, if i step up from #10 bolt, to 1/4" bolt
https://www.usplastic.com/catalog/it...d=35434&catid=
For cues i use 3/8"-10 joint, so this is what i was planning to keep on hand.
More or less "just-in-case" because so far wood without insert works ok. I saturate with super glue, and then wax. But i see a lot of you guys use inserts and it's a good idea.
https://www.usplastic.com/catalog/it...d=35439&catid=
Thanks for the advice and info!
smt
Edited - OK. More search, found Atlas billiard sells the rolled rod. Thanks!
This is close to what i need for furniture project, if i step up from #10 bolt, to 1/4" bolt
https://www.usplastic.com/catalog/it...d=35434&catid=
For cues i use 3/8"-10 joint, so this is what i was planning to keep on hand.
More or less "just-in-case" because so far wood without insert works ok. I saturate with super glue, and then wax. But i see a lot of you guys use inserts and it's a good idea.
https://www.usplastic.com/catalog/it...d=35439&catid=
Thanks for the advice and info!
smt
Edited - OK. More search, found Atlas billiard sells the rolled rod. Thanks!
Total Comments 0
